產品編碼 | D-Think_010_PN65N |
協議標準 | ISO/IEC 14443A,ISO/IEC 14443 B,ISO/IEC 15693, ISO/IEC 18092,F(xiàn)eliCa,Mifare 1K/4K |
工作頻率 | 13.56MHz |
識別距離 | 5-8CM |
安全模塊 | 有 |
供電 | USB供電 |
外圍芯片接口 | SWP、NFC‐WI |
通訊接口 | UART、I2C、SPI |
電氣特性 | 與PN544(PN65N)相一致,見PN544(PN65N)數據手冊 |
外型尺寸 | 15*18*1.9mm |
工作溫度 | -40 - +65 ℃ |
儲存溫度 | -25 - +85 ℃ |
引腳號 | 引腳名稱 | 類別 | 描述 | 備注 |
1 | GND | Other | Ground | |
2 | NC | NC | | |
3 | EXT_SW_CTRL | UICC | Control output signal for external UICC power switch | |
4 | NC | NC | | |
5 | NC | NC | | |
6 | NC | NC | | |
7 | NC | NC | | |
8 | A0/NSS (IF0) | Host | Functionality depends on selected interface | |
9 | NC | NC | | |
10 | NC | NC | | |
11 | NC | NC | | |
12 | NC | NC | | |
13 | NC | NC | | |
14 | IFSEL2 | Configuration | Host interface select input 2 | |
15 | IFSEL1 | Configuration | Host interface select input 1 | |
16 | RST_N | SE | RST pin of ISO IEC 7816 interface of SmartMX | 僅PN65N |
17 | VMID | Antenna | Contactless receiver Voltage reference | |
18 | RX | Antenna | Contactless Receiver input | |
19 | PF1 | Antenna | Antenna connection for card emulation | |
20 | NC | NC | | |
21 | TX1 | Antenna | Contactless Transmitter output 1 | |
22 | TX2 | Antenna | Contactless Transmitter output 2 | |
23 | PF2 | Antenna | Antenna connection for card emulation | |
24 | GND | Other | Ground | |
25 | NC | NC | | |
26 | SIGIN | SE | NFC-WI data input | |
27 | VEN_MON (LX) | Other | DCDC coil | PN544 |
Enable of the battery voltage monitor | PN65N | |||
28 | I/O1 | SE | IO pin of ISO IEC 7816 interface of SmartMX | 僅PN65N |
29 | VBAT | Power | Battery voltage | |
30 | SIGOUT | SE | NFC-WI data output | |
31 | SVDD | SE | SmartMX power,fixed to 1.8V | |
32 | SWP | UICC | SWP data connection | |
33 | SIMVCC | UICC | Power output to supply the UICC | |
34 | VEN | Host | Enable/disable LDO regulator | |
35 | PMUVCC | Host | UICC Power in from mobile PMU | |
36 | CLK | SE | CLK pin of ISO IEC 7816 interface of SmartMX | 僅PN65N |
37 | NRESET | Host | PN544有用,PN65N中接PVDD | |
38 | NC | NC | | |
39 | SDA/SCK (IF2) | Host | Functionality depends on selected interface | |
40 | PVDD | Host | Pad supply voltage Input(VI/O) | |
41 | RXD/A1/MOSI (IF1) | Host | Functionality depends on selected interface | |
42 | IRQ | Host | IRQ output | |
43 | TXD/SCL/MISO (IF3) | Host | Functionality depends on selected interface | |
44 | IFSEL0 | Configuration | Host interface select input 0 | |
45 | GPIO5 | GPIO | Run mode selection | 僅PN65N |
46 | GPIO4 | GPIO | Download mode control | 僅PN65N |
類別 | 引腳名稱 | 引腳號 | 描述 | 備注 |
Host connection pins | VEN | 34 | Enable/disable LDO regulator | |
PVDD | 40 | Pad supply voltageInput(VI/O) | | |
PMUVCC | 35 | UICC Power in from mobile PMU | | |
IRQ | 42 | IRQ output | | |
TXD/SCL/MISO (IF3) | 43 | Functionality depends on selected interface | | |
SDA/SCK (IF2) | 39 | Functionality depends on selected interface | | |
RXD/A1/MOSI (IF1) | 41 | Functionality depends on selected interface | | |
A0/NSS (IF0) | 8 | Functionality depends on selected interface | | |
NRESET | 37 | PN544有用,PN65N中接PVDD | | |
UICC connection pins | SIMVCC | 33 | Power output to supply the UICC | |
SWP | 32 | SWP data connection | | |
EXT_SW_CTRL | 3 | Control output signal for external UICC power switch | | |
SE connection pins | SVDD | 31 | SmartMX power,fixed to 1.8V | |
SIGIN | 26 | NFC-WI data input | | |
SIGOUT | 30 | NFC-WI data output | | |
CLK | 36 | CLK pin of ISO IEC 7816 interface of SmartMX | 僅PN65N | |
I/O1 | 28 | IO pin of ISO IEC 7816 interface of SmartMX | 僅PN65N | |
RST_N | 16 | RST pin of ISO IEC 7816 interface of SmartMX | 僅PN65N | |
Antenna connection pins | TX1 | 21 | Contactless Transmitter output1 | |
TX2 | 22 | Contactless Transmitter output2 | | |
RX | 18 | Contactless Receiver input | | |
VMID | 17 | Contactless receiver Voltage reference | | |
PF1 | 19 | Antenna connection for card emulation | | |
PF2 | 23 | Antenna connection for card emulation | | |
GPIO pins | GPIO4 | 46 | Download mode control | 僅PN65N |
GPIO5 | 45 | Run mode selection | 僅PN65N | |
Configuration pins | IFSEL0 | 44 | Host interface select input 0 | |
IFSEL1 | 15 | Host interface select input 1 | | |
IFSEL2 | 14 | Host interface select input 2 | | |
Other pins | VBAT | 29 | Battery voltage | |
GND | 1 | Ground | | |
GND | 24 | Ground | | |
VEN_MON (LX) | 27 | DCDC coil | PN544 | |
Enable of the battery voltage monitor | PN65N | |||
NC | NC | 2 | | |
4 | | | ||
5 | | | ||
6 | | | ||
7 | | | ||
9 | | | ||
10 | | | ||
11 | | | ||
12 | | | ||
13 | | | ||
20 | | | ||
25 | | | ||
38 | | |
歡迎光臨 D-Think | 東遠科技-廣州東遠智能科技有限公司- (http://xjmu.com.cn/) | Powered by Discuz! X3.4 |